Prewired 7443 resistor harness, simulates regular bulb installation. Each
Prewired 7443 resistor harness, simulates regular bulb installation. Each
Stocking item, 30 day return policy applies

Prewired 7443 resistor harness, simulates regular bulb installation. Each

SBx Parts
SBX:LED:7443WRF100
lbs
Add to cart
  • Description
  • More

These are Not a Recon product

Normally ships within 48 hours
Prewired 7443 resistor harness, simulates regular bulb installation. Each,  Fixes flashing and bulb out indicator problems, sold as singles  

Product information updated on 2021-09-21,  Manufactured by SBx Parts - Part Number SBX:LED:7443WRF100,  Prewired 7443 resistor harness, simulates regular bulb installation. Each,  Fixes flashing and bulb out indicator problems, sold as singles, Installing a set of 12 volt LED bulbs will provide you with more visibility, lower power useage and longer life.

If you have replaced your factory bulbs with LED bulbs and are getting dash warnings or your signal lights flash fast this is an economical way to solve the issue. Simple put in place between the affected circuit power and ground connection and the vehicle will think that a factory bulb has been installed which will eliminate the warning light or fast flashing. These are offered in both pre-wired versions which are easy to install or low cost resistors that are meant to be wired in place which is a bit more work but at a lower cost for the parts