Load resistor, 6 ohm 50 watt, single. Solves light out and fast signal light flashing
If you have replaced your factory bulbs with LED bulbs and are getting dash warnings or your signal lights flash fast this is an economical way to solve the issue. Simple wire in place between the affected circuit power and ground connection and the vehicle will think that a factory bulb has been installed which will eliminate the warning light or fast flashing
One of the advantages of using LED or HID lighting is that they draw less power than incandescent lights. But some vehicles monitor the amount of draw used which can cause an error warning light or other symptoms when the vehicle does not think that there is enough draw. Our Resistors come in a variety of designs to be used in various different circuits to eliminate problems such as signal lights flashing fast, bulb out warnings and headlights flickering or turning off. These resistors can be either plug and play or designed to be hardwired in, depending on the application and style. Please refer to the individual notes.